2019年上海“紡織服裝創意創新”研究生學術論壇
暨第十三屆紡織服裝創新國際論壇
征稿啟事
主題：“低碳·時尚·創新·科技”
論壇地點♦️：杏鑫娱乐圖文信息中心
論壇時間🌶：10月25日---10月26日（初定）
主辦單位：上海市學位委員會、上海市教育委員會
承辦單位🧖🏼♀️：杏鑫娱乐🚣🏼♀️、上海市紡織科學研究院有限公司、上海市紡織工程學會
中英智能運動服裝聯合實驗室
一、論壇背景
為進一步促進自主開展學術交流活動，達到開闊視野🤷🏻♀️、啟迪智慧、提高創新能力的目的，營造敢於探索、勇於創新的學術氛圍，並結合上海產業結構調整優化以及上海創意產業的發展，由上海市學位委員會、上海市教育委員會主辦，杏鑫娱乐、上海市紡織科學研究院有限公司🥐🤽🏽、上海市紡織工程學會和中英智能運動服裝聯合實驗室承辦2019上海紡織服裝創意創新學術論壇暨第十三屆紡織服裝創新國際論壇☢️。屆時，將邀請紡織服裝創意界國內外知名學者做專題學術演講。
二🥗👨🎤、論壇宗旨
以“時尚創意融匯科技發展👩🏿🌾，倡導低碳環保理念，共探紡織服裝的創新科技”為主旨👩🏿💃🏻，搭建交流平臺，提高科研水平和創新能力，增進校際間學術交流。以研討紡織服裝科技為基礎，引領紡織服裝工程新技術、新產品研發，促進時尚生活與綠色紡織的融合，開創紡織服裝創意產業🧈，實現紡織服裝產業由規模優勢向技術優勢的轉變，由註重產業鏈完整向價值鏈躍升轉變🧈。以科技推動生產力為著眼點，促www.engineeringvillage.com). (10pt Times New Roman, left and right margins of 2.8cm)
1. Introduction
As you can see for the title of the paper you must use 16pt, Centered, Bold, Times New Roman. Leave one blank line and then type Authors’ Name (12pt Times New Roman, Bold,centered), Department (in 11pt Times New Roman, centered), University (in 11pt Times New Roman, centered), Address (in 11pt Times New Roman, centered), Country (in Capital, 11pt Times New Roman, centered). Then you must type e-mail address of the corresponding author (11pt Times New Roman, centered).
The heading of each section should be printed in small, 14pt, left justified, bold, Times New Roman. You must use numbers 1, 2, 3, … for the sections' numbering and not Latin numbering (I, II, III, …)
2. Problem formulation
Please, leave one blank line between successive sections as here.
Equations. Equations (refer with: Eq. 1, Eq. 2, ...) should be indented 5 mm (0.2"). There should be one line of space above the equation and one line of space below it before the text continues. The equations have to be numbered sequentially, and the number put in parentheses at the right-hand edge of the text. Equations should be punctuated as if they were an ordinary part of the text. Punctuation appears after the equation but before the equation number, e.g.
c2 = a2 + b2 (1)
2.1 Subsection
When including a subsection you must use, for its heading, small letters, 12pt, left justified, bold, Times New Roman as here.
2.1.1 Sub-subsection
When including a sub-subsection you must use, for its heading, small letters, 11pt, left justified, bold, Times New Roman as here.
3. Problem solution
Tables. Tables (refer with: Table 1, Table 2, ...) should be presented as part of the text, but in such a way as to avoid confusion with the text. A descriptive title should be placed above each table. The caption should be self-contained and placed below or beside the table. Units in tables should be given in square brackets [meV]. If square brackets are not available, use curly {meV} or standard brackets (meV).
Figures. Figures (refer with: Figure 1, Figure 2, ...) also should be presented as part of the text, leaving enough space so that the caption will not be confused with the text. The caption should be self-contained and placed below or beside the figure. Generally, only original drawings or photographic reproductions are acceptable. Only very good photocopies are acceptable.
Table 1 The sample of table
Type | Time (h) | Results |
T1 | 1 | Good |
T2 | 3 | Excellent |
T3 | 5 | Bad |
T4 | 7 | Very bad |
Figure 1 SEM of sample.
If your paper deviates from these specifications, your paper will be rejected immediately. When citing references in the text of the abstract, you should type the corresponding number in square brackets as shown at the end of this sentence [1].
Page Numbers. Do not print page numbers.
Literature References. References are cited in the text just by square brackets [1]. (If square brackets are not available, slashes may be used instead, e.g. /2/.) Two or more references at a time may be put in one set of brackets [3,4]. The references are to be numbered in the order in which they are cited in the text and are to be listed at the end of the contribution under a heading References, see our example below.
4. Conclusion
Please, follow our instructions faithfully, otherwise you have to resubmit your full paper. This will enable us to maintain uniformity in the journal. Thank you for your cooperation and contribution.
Attention: You must follow the reference format strictly, especially the punctuations.
References:
[1] Huang (Surname) FC(Initial), Boltong MG, Bermudez O, Planell JA. Formulation and setting times of some calcium orthophosphate cements: a pilot study(Paper title) [J] (For Journal). Textile Research Journal (Full name of the journal), 1993, 4(3):53-58. [Year, Volume (issue): page number]
[2] Zhang H(Author). Textile Materials (Book title) [M] (For Book).Beijing: (Press address)China Textile Press (Press name), 1989:157-182. (Year: page number)
[3] Brown W, Chow LC(Application author). Combinations of sparingly soluble calcium phosphates in slurries and paste as mineralizers and cements(Patent title) [P] (For Patent). US (Country), Patent No. 4612053(Patent number), 1986. (Year)
[4] Li FY (Author). PANI electro-spinning process and electrical properties (Title of the thesis) [D] (For thesis). Shanghai: (Press address) Donghua University (Affiliation), 2001. (Year)
